The FLOYD has two materials, so treat them differently
The FLOYD ankle boot is not a single-material shoe. The upper is moka suede, while the inside is lined with leather and has a leather insole. That split matters: a product that cleans suede well can be too harsh on finished leather, and a leather conditioner can darken or matt suede. The routine below keeps the two apart.
The boot also has a genuine leather sole with Blake construction, and a side zip. Neither changes the basic care steps, but they are worth knowing before you start applying anything.
A simple cleaning routine for the suede upper
- Brush dry, not wet: Use a soft suede brush to lift surface dust and revive the nap. Work in one direction, with light strokes. Do this before any deeper cleaning so you are not pushing grit into the suede.
- Spot-clean only where needed: For marks, use a suede eraser or a cloth barely dampened with water, then let the area dry away from direct heat. Avoid soaking the whole upper; over-wetting suede can stiffen the nap and leave water lines.
- Let the boots air-dry fully: Stuff the boots lightly with paper to hold their shape and leave them at room temperature. Do not put them on a radiator or in direct sun. The FLOYD's shaft is 15.5 cm, so a small amount of paper is enough to support it.
Conditioning the leather lining and insole
The leather lining and insole are the parts that touch your foot, so they deserve gentle care. A small amount of leather conditioner on a soft cloth, worked into the lining and insole and then buffed, can help keep the leather supple. Use it sparingly; excess product can make the inside slippery or transfer to socks.
Do not apply suede conditioner or leather cream to the moka suede upper unless the product is explicitly made for suede. The supplied FLOYD information does not include a specific conditioner recommendation, so choose a product labeled for suede and test it on a small hidden area first.
What the FLOYD record tells us about its materials
- FLOYD: Upper is suede in moka; lining and insole are leather. This is the reason the upper and the inside need separate care products rather than one all-purpose cleaner.

FLOYD - FLOYD: Genuine leather sole with Blake construction; heel 3 cm, shaft 15.5 cm, sole 0.8 cm. The leather sole should not be soaked, and the 15.5 cm shaft gives you a clear idea of how much paper to use when drying.
Protecting the FLOYD from rain and wet pavements
- Use a suede protector before the first wear: A fluoropolymer-free suede protector spray can help water bead on the surface. Apply it outdoors or in a ventilated room, let it dry fully, and reapply according to the product's instructions. The supplied FLOYD information does not confirm waterproofing, so treat the boot as water-resistant at best, not waterproof.
- Avoid deep puddles and prolonged wet: The leather sole and Blake construction are not described as sealed or waterproof. If the boots get wet, blot them with a cloth, stuff them with paper, and let them dry naturally away from heat.
- Let wet boots dry completely before wearing again: Wearing damp suede can stretch it and set creases. Give the FLOYD a full day to dry if it has been caught in a shower.
The side zip and leather sole: small habits that help
The FLOYD has a side zip, which makes it easy to put on and take off. Keep the zip free of grit by brushing around it when you clean the suede. If the zip feels stiff, a small amount of wax or graphite on the teeth can help, but avoid getting product on the suede.
The leather sole will show wear at the heel and toe first. A thin layer of sole edge dressing can keep the edges looking neat, but the supplied information does not include a specific sole-care product. Inspect the sole periodically and have a cobbler check the Blake stitching if you notice separation or excessive wear.
Between-wear habits that make the routine easier
- Rest the boots: Alternate the FLOYD with another pair so moisture from your feet can evaporate fully between wears.
- Use shoe trees: Untreated wooden shoe trees can absorb moisture and help the boots keep their shape. Insert them while the boots are still slightly warm from wear.
- Store them clean and dry: Brush off dust before storing, and keep the boots in a breathable bag rather than a sealed plastic box.
What the supplied FLOYD information does not cover
The FLOYD record does not include a manufacturer care label, a recommended conditioner, or a waterproofing claim. That means the steps above are general leather and suede care practices, not a confirmed FLOYD-specific procedure. When in doubt, test any product on a small hidden area first, and follow the product label over general advice.
The record also does not state how the suede was treated or whether the leather sole is sealed. If you need a definitive answer for a warranty or repair question, contact the retailer or a qualified cobbler rather than relying on assumptions.

